|
|
Details
|
|
| The SMPS24-10 is a fully regulated adjustable output voltage power supply. The output voltage is normally preset at the factory. Please consult Customer Services for your voltage requirements when ordering. | |
| Note: | There are no user serviceable parts inside the power supply and it is extremely dangerous to remove the cover while the unit is switched on, as the cover may contact live circuitry inside. |
|
Stock Code
|
Description
|
Output Voltage
|
Current
|
|
912.030.00
|
SMPS 24-10
|
22-29V
|
10A
|
| Specifications | |
| Output Ripple Voltage @ Full Load | < 0.5% |
| Load Regulation (Zero to Full Load) | < 2.0% |
| Line Regulation (220-240V) @ Full load | < 0.1% |
| Output Voltage Adjustable Range | 22-29V DC |
| Output Current Continuous | 10A Max at 24V DC |
| Short Circuit Current Limit | 15A DC (approx) |
| Output Power Continuous | 280W Max |
| Power Factor @ Full Load, 200V AC Input | > 0.99 |
| Frequency of Operation | 80kHz |
| Input Fuse | 6A Slow Blow 250V AC internally accessible |
| Output Fuse | 20A HRC Fuse internally accessible |
| Thermal Protection | Internal protection circuitry on board |
| Mains Input Nominal | 230/240V AC 50/60Hz (110V AC possible) |
| Indication Lamp | Power on LED |
| Dimensions | L - 370mm W - 175mm H - 87mm |
| Input Current @ 230V AC | 2.3A rms |
| Weight | 3.3 Kg |
|
The power supply is factory preset at the customer specified output voltage (usually 27.6 DC or 24V DC).
|
|
|
|
Mains input is via a 3-pin plug and flex; output terminals for + and - connections are provided outside the case.
|
|
The power supply is not recommended for float charging batteries above 60AH capacity (at C/20 rate).
|
|
Installation
|
|
The power supply should be installed in a well ventilated area and not enclosed where excessive heat build up can occur. Do not install or mount above any hot air discharge/air-conditioner/radiator or similar equipment. Mounting outside or in a wet/damp environment is also not recommended. Keep fan intake/output vents well clear of any material likely to block them.
|
|
Batteries
|
|
Sealed and open lead acid batteries can be charged. Please specify nominal output float voltage and size of battery when ordering.
|