Details
|
|
The SMPS12-20 is a fully regulated adjustable output voltage power supply. The output voltage is normally preset at the factory. Please consult Customer Services for your voltage requirements when ordering. | |
Note: | There are no user serviceable parts inside the power supply and it is extremely dangerous to remove the cover while the unit is switched on, as the cover may contact live circuitry inside. |
Stock Code
|
Description
|
Output Voltage
|
Current
|
912.023.00
|
SMPS 12-20
|
11-14.5V
|
20A |
Specifications | |
Output Ripple Voltage @ Full Load | < 0.5% |
Load Regulation (Zero to Full Load) | < 2.0% |
Line Regulation (220-240V) @ Full load | < 0.1% |
Output Voltage Adjustable Range | 11-14.5V DC |
Output Current Continuous | 20A Max |
Short Circuit Current Limit | 35A DC (approx) |
Output Power Continuous | 280W Max |
Frequency of Operation | 80kHz |
Input Fuse | 6A Slow Blow 250V AC internally accessible |
Output Fuse | 20A HRC Fuse internally accessible |
Thermal Protection | Internal protection circuitry on board |
Mains Input Nominal | 230/240V AC 50/60Hz (110V AC Possible) |
Indication Lamp | Power on LED |
RFI Suppression | AS/NZS 2064 Class A |
Dimensions | L - 370mm W - 175mm H - 87mm |
Input Current @ 230V AC | 2.3A rms |
Weight | 3.3 Kg |
For 110V AC operation contact ETE. |
The power supply is factory preset at the customer specified output voltage (usually 13.8 DC or 12V DC). |
|
Mains input is via a 3-pin plug and flex; output terminals for + and - connections are provided outside the case.
|
The power supply is not recommended for float charging batteries above 60AH capacity (at C/20 rate).
|
Installation
|
The power supply should be installed in a well ventilated area and not enclosed where excessive heat build up can occur. Do not install or mount above any hot air discharge/air-conditioner/radiator or similar equipment. Mounting outside or in a wet/damp environment is also not recommended. Keep fan intake/output vents well clear of any material likely to block them.
|